Awning lights that have both a switch and a remote can sometimes act strange.
Forest river led awning lights not working.
As wagonmaster said the lights are just in a soft plastic strip and they are slid inside a split channel under the awning.
My walk through was not the greatest and i don t see anything in the manual about the lights.
On many rigs it s located behind the rear wall of the pass through basement storage.
If all fuses are found to be o k.
However during the model year it may be necessary to make revisions and forest river inc.
Think about it as if two separate power sources connected to same light.
The try turning on and operating them with the remote.
Remove the old led strip install the boogey lights strip where the old led strip used to be and connect the power lead coming from the boogey lights strip to the existing 12vdc power leads that were used for the old led light strip.
If you turn them on with a switch then the remote may not perform as expected.
We have the same trailer and those led lights are hard wired not remote controlled.
We just reinstalled this yesterday with a much more weather resistant stri.
Replacing and installing rv awning led light strip easy install update 7 1 18.
First check the ground connections of the cable ends and the connectors it plugs into.
Reserves the right to make changes without notice including prices colors materials equipment and specifications as well as the addition of new models and the discontinuance of models shown on this website.
I can never remember which switch controls them just trial and error but there is a switch either on the main switch panel or on one of those panels between the tv.
There are two ways to turn them on and off.
Turn the switch off.
Then the led strip light circuit may have burned out and the light assembly may have to be replaced.
If still not working you ll need to locate the power converter and make sure it s plugged into it s outlet.
The existing wall switch will turn on off the led light.
If it s not plugged in plug it in and tie the plug so it can t vibrate out of the socket.