A green light will flash and a beep will sound on the activation tool for each successful tpms response.
Ford expedition tire pressure sensor reset.
3 cycle ignition from the off to run position 3 times ending in the run position.
Direct tpms tpms sensors are installed in the wheel tire pressure is communicated via radio frequency rf technology from the sensor to the vehicle s ecu.
The tire pressure sensor on models in after 2007 can be read only with some specified diagnostic tools.
Tire pressure sensor activation 1 turn the ignition switch to on position.
4 press and release brake pedal.
Press and hold the start button until a chime sounds.
When changing any of your tires take care to avoid damaging the sensor.
1 inflate all tires to pressure listed on vehicle placard.
Press and hold the start button until a chime sounds.
Each road tire is equipped with a tire pressure sensor which is located inside the wheel and tire assembly cavity.
2 turn ignition to off position and press and release brake pedal.
Hold tool against the sidewall of the tire near the valve stem.
Inflate all tires to pressure listed on vehicle placard 2 with the vehicle off press and release the brake pedal.
Inflate all tires to pressure listed on vehicle placard 2 with the vehicle off press and release the brake pedal.
2 place the activation tool on the left front tire sidewall at the tire valve stem.
Since the sensor is attached to the valve stem it is covered by the tire and not visible unless the tire is removed.
Vxscan el 60448 tpms reset tool can help you reprogram all tires easier with 3 steps.
Locating the tire pressure sensor.
When one or more sensors are replaced in a ford expedition a tpms relearn is recommended to write the id s to the vehicle s ecu to turn the tpms light off.
Power off by pushing the button 1 time.