To return the part to its bent state.
Flatten sheet metal part solidworks.
All features after flat pattern1 appear only in the flattened sheet metal part.
I have a sheet metal part with two configurations.
On one of the configurations 001 the bends all flatten correctly.
These improvements also provide better flattened geometry for certain corner treatments lofted bends and in some cases where cuts intersect bend regions.
Wrong flat pattern in view palette.
As shown in the figure below the flat pattern view is the same as the front view and shows the part in a bent state.
Here are a few simple steps to take in order to flatten your imported part.
In the featuremanager design tree select the part and click flatten sheet metal toolbar.
Improvements to flattening sheet metal parts make flattening succeed for complex shapes which previously failed.
Set the sheet thickness and default bend radius.
To hide the bend lines expand flat pattern1 right click bend lines and select hide.
To flatten the entire part if the flat pattern1 feature is present unsuppress flat pattern1 or click flatten on the sheet metal toolbar.
However when i switch over to the second configuration 002 which is a mirrored part to the first config one of the bends that were mirrored will not flatten.
Stop putting a small flat section on your part just to get it to convert to sheet metal.
Upholstery clothing even carbon fiber layups can be calculated using this feature.
All features before flat pattern1 in the featuremanager design tree appear in both the folded and flattened sheet metal part.
When cleared the body is consumed by the convert to sheet metal feature.
In the cut list right click the body and click flatten.
I checked the bend radius and it is at 015 for both configs.
The bend lines are shown by default when you unsuppress flat pattern1.
In the solidworks open dialog set the file filter to the required file type in this example it is a step file step stp.
In either the featuremanager design tree or the cut list right click the flat pattern feature for the part and click unsuppress.
Select keep body if you want to keep the solid body to use in another convert to sheet metal feature.
Flatten it by converting it using the insert bends command instead.
When the flat pattern drawing view of a solidworks sheet metal part displays the part in the bent condition this can indicate an issue with the suppression state of the flat pattern feature.
It is designed for materials like cloth or leather but can be used for metal if there will be forming involved.