The roof decking is left slightly shorter than the rafter ends creating a gap between the roof and the gutter.
Fix gap between gutter and shingles.
Can someone tell if there is a building code that discusses the height of the gap between wall siding above an adjacent roof and the shingles and where to find it if it exists.
There is wood siding 4ft x 8ft sheets on the neighboring wall that ends about 1 5 inches above my roof.
Unfortunately in most homes this is not the case.
The gutters then direct the water to a downspout allowing the water to run down until it reaches the ground.
When the roof shingles do not extend past the metal drip edge the water will suck back on the metal drip edge this is called capillary action and run behind your gutters.
Usually you can also work those loose without removing shingles.
Smooth the caulk bead with your finger and begin caulking the joint between the fascia board and the soffit also known as the eave.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
Capillary action is a water activity in which water adheres to a surface and follow the surface around.
Slowly move down the joint to apply a steady bead of caulk into.
When there is rain the water is expected to roll down the roof and into the gutters.
But first let s discuss you can t afford to ignore a leaky gutter.
Install using proper roofing nails.
My roof ends at the neighboring wall.
Usually this is due to.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Home centers sell rolls of 6 in.
Tighten up loose gutters.
Over time rain gutters often start to pull away from the roof allowing water to drip over the gutter sides or between the gutters and the walls.
Water leaking between gutter and fascia.
Screw the bottom in place with rubber washered screws.
Although covered by a layer of shingles this gap extends the full roof line of your home and is an ideal place for wildlife specifically squirrels to enter.
Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier.
Often a slice of sheet metal from a coil of alum can be riveted to the back side of the gutter this is cut to size so that it either tucks up under the drip edge or can be attached to the fascia.
It should extend up to the bottom or nearly so of the shingles.
Slip an additional shingle in under those shingles install them oriented so the normally top edge of the shingle is the bottom edge but make sure they stay face up.